Answers to frequently asked questions about earwigs in wells.

For a free brochure containing the information on this page, contact the nearest DNR office and request publication number WS-029.

Table of contents

  1. What's an earwig?
  2. How do earwigs contaminate wells?
  3. How do I know if earwigs are a problem in my well?
  4. What can I do to get rid of earwigs in my well?

WHAT'S AN EARWIG?

The earwig is a brown insect about an inch long and a quarter-inch wide. Its most distinguishing feature is its fierce-looking tail pincer (see drawing). Earwigs usually don't pose much of a problem -- unless you find them in your well. Even then, it's the bacteria they bring with them, rather than the earwigs themselves, that give humans trouble.

Earwigs are scavengers. They eat small insects and decaying plant and animal matter. Warm summer weather makes earwigs more active. They may stay active in the fall if they find relatively warm shelter.

Earwigs live in damp areas, usually around, underneath or in vegetation. They can also be found in and under piles of wood, lumber and other items stored around building foundations. Although other insects also fall into wells, the cool, moist environment of a well casing provides earwigs with a favorite home.

HOW DO EARWIGS CONTAMINATE WELLS?

Earwigs and other small invertebrates can contaminate well water with bacteria, some of which may cause illness or disease. For example, earwigs may have entered a septic system, then your well -- bringing potentially harmful bacteria, viruses or other microbes with them.

HOW DO I KNOW IF EARWIGS ARE A PROBLEM IN MY WELL?

It's a good idea to have your well water tested each year for coliform bacteria. These bacteria normally do not cause illness or disease themselves, but their presence means other disease-producing microbes may be present. Besides earwigs and other insects, your well may be vulnerable to bacterial invaders from a leaking septic system or animal waste. You won't know unless you get your water tested regularly -- or until you get sick.

WHAT CAN I DO TO GET RID OF EARWIGS IN MY WELL?

  1. Clean away debris such as wood piles and vegetation from around your well casing.

  2. Install a vermin-proof well cap or seal (figure 2) to prevent earwigs and other insects from entering your well. This will also keep out snow fleas or springtails, millipedes, mites and other creatures (figure 3) that may contaminate your well.

    Wells constructed before February 1991 probably don't have a vermin- proof cap or seal. A vermin-proof cap has a gasket around the inside to prevent entry of insects and other vermin. The cap has a screened vent that allows air into the well. These may cost $40 to $80 depending on the type and who installs it.

  3. Treat your well with chlorine to kill any bacteria that might have been brought into your well by earwigs or other insects.

    If a well is producing bacteria-laden, unsafe water, and earwigs have been seen in or near the well, they may be the culprit. If the problem persists after a few chlorinations, especially if bacterial counts are increasing, you'll need to try more drastic methods.

  4. Physically remove earwigs from your well if repeat treatments with chlorine have not solved your bacteria problem.

    As you search for the cause of a persistent bacteria problem, you may be horrified to find that hundreds of earwigs or other insects have invaded your well! Even after disinfecting the well, the earwigs simply fall to the bottom of the well, providing a food source for continued bacterial growth.

    This is one reason why well-water samples taken after disinfection may have higher bacterial counts than earlier samples. In some cases, hundreds of earwigs have been dredged from the bottom of a well. The insect bodies were bleached white from chlorine treatments, but still intact.

    To solve this problem, you'll have to remove the earwigs from the well. This can be done either by bailing out the well using a drilling rig or blowing the insects out with compressed air. A well contractor can provide these services. Once the well has been cleaned, it should be disinfected with chlorine again and re-sampled for bacteria.

  5. Get your wellwater tested for coliform bacteria once a year. This is a cheap way to identify at least some of the threats to your drinking water supply before they affect your health.

    Finally, for information on the use of insecticides for controlling earwigs and other pests in outdoor areas such as lawns and around homes, contact your local county extension office. The use of chemicals or pesticides inside a well itself, other than chlorine, is strictly prohibited by federal and state law.

For more information about well contamination and vermin-proof well caps, contact a licensed well driller or pump installer or your local DNR drinking water specialist (Figure 4). For water sample test kits, contact a private laboratory certified for bacteria testing of water (also listed in the yellow pages under "Laboratories-Testing"), or call the State Laboratory of Hygiene at (608) 262-1295 or 1-800-442-4618.

This brochure was prepared with the assistance of UW Extension.



Last Modified: Tuesday January 28 2003